REQUIREMENTS:
1) Any version of mig33
2) A multi set of 10 IDs
3) An ID registered at MMG server , use this link Buy mmg to register your ID
4) MMG IP and PORT (You will get IP and PORT after you register your ID)
CONNECT TO MMG
•Open your normal mig(any version you like) and goto connection settings
•
•You will get new IP and PORT after you register your mig33 ID with us, put this IP address and PORT and press connect
•
•
•that�s all you need to connect to MMG
HOW TO USE THIS GATEWAY?
•Login your ID normally after you are connected to gateway(Only registered IDs can login via this gateway)
LOGIN MULTISET:
Note: Every command starts with dot (.)
•Join any room and write login command in room, here is the login command:
•login command: .log multi_set_without_last_integer multi_password
•example:
•If your multi set is gateway1 to gatway10 and password of multiset is 123123 then login command would be: .log gateway 123123
•Wait few seconds after sending login command, you will get message if your set is logged in.
Note: although this command is written in chat room but other users would not be able to see it.
Mix multi login , saving and retrieving multi sets:
•You can save you multi set and retrieve in future with the following simple commands
•Save set command: .save multi_pwd id1;id2;.......;id10 (you can use either mix multi or multi series ,just separate the IDs by semicolon)
•As the set is saved permanently in database so you don't need to save at every login, use load command and your set will be loaded automatically
•Load set command: .load
•Note: Load command will load the last saved set and automatically login the set
OTHER COMMANDS:
•After your IDs get logged in, you can use following commands to control your multi set
•Room join command: .J
•Room leave command: .L
•Multikick enable: .me (This command will enable multikick mode, Note that this feature is automatically enabled after you login your multiset )
•Multikick disable: .md (Multikick feature will be disabled, all kicks will be normal kicks)
•Kick user: make sure your multikick is enabled then press menu then kick then select and kick the target as you normally do. Can you believe this would be multikick instead of normal kick
•
•
•Multi text: .f write_multi_text_here, this command will send text with your multi IDs
•Private text: .pf pvt_target pvt_text , this command will send multi text in private
•Multi Dc: .dc this command disconnects your multi set